Thank you for purchasing the Synthrotek 3U ADAPT series! The ADAPT series of modules use an original Synthrotek footprint designed to take 3.5mm mono, RCA and banana jacks for maximum configurations! The following modules can use this assembly guide:

4×2

ADJ

P.OUT 1U Tile

SKIP

  This is a fairly easy build, but it is very important to get all the components properly soldered into the PCB in the correct placement. If you feel like you can handle it, please proceed! If not, get some help from a friend with experience or purchase a fully completed unit.

 

Bill of Materials

Bills of Materials with Mouser part numbers:

ADAPT 4×2 BOM

ADAPT ADJ BOM

ADAPT SKIP BOM

P.OUT 1U Tile BOM

INSTALLING THE 3.5mm Jack

Take the 3.5mm mono jack as shown below.  It is best to wait to have all the jacks installed into the PCB BEFORE SOLDERING. 

INSTALLING THE BANANA JACK

Take the banana jack and place it through the PCB and tighten down the jack before inserting into the PCB.  Banana jacks do not have a ground connection. There are ways to connect a ground from your banana style module system.  It is best to wait to have all the jacks installed into the PCB BEFORE SOLDERING. 

Place the jack lead through the PCB. It is best to wait to have all the jacks installed into the PCB BEFORE SOLDERING. 

INSTALLING THE RCA JACK

Take the components off the jack as shown below.   You will need all of these parts.

Place RCA jack through the panel and reassemble it with the nut and the ground connection behind the panel and sticking off the edge as shown below. It is best to wait to have all the jacks installed into the PCB BEFORE SOLDERING. 

Carefully bend the ground lead over as shown below and make a candy-cane style hook from the provided lead clipping. It is best to wait to have all the jacks installed into the PCB BEFORE SOLDERING. 

You can now turn the project over and solder in your RCA candy-cane ground hook.  You can then solder the rest of your leads while making sure the PCB is squared up with the panel.

FINISHED PROJECT

Congrats on your build!  The ADAPT series has different signal routing options.  Plug in some signals and get to work or play!